BJ-02 - Banjo Pickup with PBJA Jack Assembly

$154.95

This basic BJ-02 comes with a simple metal jack assembly and installs in minutes. The light weight BJ-02 sensor does not interfere in any way with the natural acoustic tone or output of the banjo. 

 Sound Clips:  Clip 1     Clip 2

Technical

    The BJ-02 series sensor is designed to work on any banjo. Five string, tenor, six string, open backs; all sound excellent with this pickup. Installation of the pickup system takes about ten minutes and everything that you need to complete the installation is included with the system.The pickup comes supplied with 3M VHB tape for mounting the sensor (as well as a small packet of 5 minute epoxy for more permanent installations).
     This particular placement of the sensor allows the pickup to "hear" just what the banjo is doing. The center foot of the bridge is driving the element directly for maximum output and clarity and it is due to this same placement of the element that also gives the BJ-02's their superior anti-feedback characteristics. It is very difficult for feedback to drive the pickup in reverse due to the overall stiffness of the bridge area.
     On a 'normal' banjo with a three footed bridge, the pickup is to be installed on the underside of the head directly under the center foot of the bridge. On tenor banjos or banjos having a two footed bridge, the suggested placement for the pickup is on the underside of the head directly under the bass side bridge foot.

View Installation Instructions (pdf)

Amplification

     This pickup has been designed to operate properly and sound terrific without the use of a preamp when plugged into any 'normal' amp (guitar amp, bass amp, etc.) As with any pickup, the sound can be further enhanced with an outboard preamp. If you require the ability to plug directly into a P.A. or mixer then you may wish to add our Mini Pre belt clipable preamp.